[. . . ] The use of this appliance by young children or disabled persons must be supervised at all times. - Check that the power rating of your appliance matches that of your electrical system. Any commercial use, inappropriate use or failure to comply with instructions, the manufacturer accepts no responsibility and the guarantee will not apply. [. . . ] - Unplug your appliance as soon as you have finished using it and when you are cleaning it or in the event of a power failure. - Do not use your appliance if it is not working correctly or if it has been damaged. If this happens, please contact an approved service centre (see list in the service booklet). - If the power supply cord is damaged, it must be replaced by the manufacturer, their after-sales service or a person with similar qualification to avoid any danger. - Any intervention other than cleaning and normal maintenance by the customer must be carried out by an approved service centre. - Never place the appliance, the power cord or the plug in water or in any other liquid. - The power cord must never be close to or in contact with the hot parts of your appliance, close to a source of heat or resting on a sharp edge. - For thick mixtures, you can always stop the appliance during preparation to push the ingredients back down onto the blades. - Over time the strong coloured natural juices from food such as carrots and beetroot may stain the plastic parts of your appliance - this is normal. - This parts may be cleaned by soaking them in mild bleach (non abrasive) straight after use. - Check the electrical connection and/or that the blender jug is correctly positioned. - If your appliance still does not work, please contact an approved service centre. - Place the blade unit (d3) in the jug (d2) and fix it in position by turning until it locks (1). - Make certain the markings M and L located under the blade unit are set opposite each other M - Position the blender jug (d) on the motor unit (a) (2). [. . . ] - Place the blade unit (d3) in the jug (d2) and fix it in position by turning until it locks (1). - Make certain the markings M and L located under the blade unit are set opposite each other M - Position the blender jug (d) on the motor unit (a) (2). - Put all the ingredients into the jug without going over the maximum level (1, 2 l). [. . . ]